![]() It also has a slight smell to it that you will notice. It’s very lightweight and is still flexible after it is dried. Instead, it remains soft but hard enough to maintain the paw print impression. This clay does not harden as you would expect. We just put it off to the side and allowed it to dry over this amount of time. Dryingįor drying, the product instructions recommend that you dry the front side for 24 hours and then turn it over and allow it to continue drying for a few days. Each time we messed up, we would simply roll the clay back into a ball and then flatten it out again. We spent a good 20 minutes trying to get a perfect impression and it was fine. You won’t have to worry about the clay drying up as long as you work within a reasonable amount of time. This clay is very easy to work with so it is forgiving and you have lots of opportunities to get it right. Some of the other ones weren’t pushed down properly in some areas or had lint or something else stuck in the impression. It took us about five different tries before we ended up with a print that we were happy with. With this clay it’s no big deal, you can simply start over and re-roll it out and try again. It’s not likely that you will make a perfect paw print or one that you are satisfied with on the first try. We found that this made it easier to pull her paw back out without the clay sticking to it. Tip: put a little bit of water on the paw before you push it into the clay. We trimmed these the best that we could and also trimmed her toenails so that we could get a good clean impression of her paw. Since our dog is a mini Goldendoodle, she has lots of curly hair that grows on the bottom of her paws. It’s important to note that we trimmed the hair on the bottom of her paw before doing this. She wasn’t particularly fond of it but she is a good girl and always aims to please.īe sure and clean off any debris from your pet’s paw or that debris will end up in the impression. We just grabbed her hand and positioned it where we wanted it and held it down into the clay for a few seconds. Our dog is well behaved so it was no big deal for us. This may be a difficult part depending on how well behaved your little rascal is. With the clay rolled out to the proper size, you are ready to put your pet’s paw into the clay. ![]() ![]() Make sure that it is a little bit larger than this cut out so that you will be able to have a clean cut out. You will want to roll the clay out to about half an inch thick or until it covers the area of the rectangle cut out that you will be using. Just make sure that you are using a flat surface underneath the area that you were working with. We used aluminum foil because we were out of parchment paper at the time. You will also want to make sure you are working on a surface that the clay will not stick to such as parchment paper or aluminum foil. The small one that it came with just didn’t get the job done. The product comes with a small rolling pin but we found it easier to use a large rolling pin that we had in our kitchen. The first thing that you will want to do is open the clay and flatten it out using a rolling pin. Rather than simply giving you a way to have an impression of your pet’s paw, you have a picture of your pet that makes it even more personable. The product that we chose has everything that you need to create a paw print impression as well as a framed shadowbox that it can be installed in next to a picture of your pet. ![]() This product is affordable, easy to work with and the end result was exactly what we were looking for. We used this paw print impression kit to create an impression of our mini Goldendoodle’s paw. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |